how to deal with models without skins (the JPG)
Posted: Sat Jul 10, 2004 5:18 pm
(post deleted because problem has been solved)
The Wonderland Board
A place to discuss all things Wonderland!
https://pcpuzzle.com/forum/
how to deal with models without skins (the JPG)
Page 1 of 1
Posted: Sat Jul 10, 2004 7:46 pm
The first picture looks good Linky, I think it's called 'Black Cat in a Coal Cellar'
Posted: Sun Jul 11, 2004 11:31 am
okay nevermind, I think I figure out what I did wrong.
In milkshape under "materials" I need to properly set the color/lighting settings "ambient", "specular", "diffuse", etc. I learned this after I found a model of a pumpkin that already has color and stuff w/o using any skins whatsoever. In fact, by using those settings properly, apparently you can create a useable model without using any skins at all (but of course, without skins the model will have a "plasticky" look and lack textures, but hey it's a start!).
With this new knowledge, hopefully I'll have the statue of liberty (and a few other stuff I snarfed from the 'net) ready to post by the end of today.
In milkshape under "materials" I need to properly set the color/lighting settings "ambient", "specular", "diffuse", etc. I learned this after I found a model of a pumpkin that already has color and stuff w/o using any skins whatsoever. In fact, by using those settings properly, apparently you can create a useable model without using any skins at all (but of course, without skins the model will have a "plasticky" look and lack textures, but hey it's a start!).
With this new knowledge, hopefully I'll have the statue of liberty (and a few other stuff I snarfed from the 'net) ready to post by the end of today.
Posted: Sun Jul 11, 2004 1:05 pm
Hurry up, I can't wait to see them. 
