The Wonderland Board

I would like to know how to make water above ground for streams and waterfalls and how to make water low so you can make a hole in the ground or something like that, and finally how to make your stinker underwater. Thanks.

StinkerSquad01 wrote:I would like to know how to make water above ground for streams and waterfalls and how to make water low so you can make a hole in the ground or something like that, and finally how to make your stinker underwater. Thanks.

I'll tell you.
Awnsers:
Follow the steps for stinker underwater.
1)Go to Tilemode.
2)Ok you see the function called WHight? Make it go bigger from - to non -.
3)If seccessful. you will see water ontop of the floor.

This sould awnser the water on top for waterfalls but to be sure:
1)Get a wall. Then make WHight go above the wall.
Then use the waterfall object.
As for hole. Easy!
1)Use floor.
2)Use Xtrude it is a customizable hight meter then set ones.
3)make it to - numbers.
4)once it shows water. make it lower then use the logic controller and make it wall.
Hope this helps.
and i hope its not that complicated

Thanks tails, nothing was complicated beacause I have already started level making. Now I can finally make real waterfalls and crevices, thanks in advance.