Page 1 of 1
AAAAAAAAAAAAAAAHHHHHHHHHHHHHHH!!!!!!!!!!!!!!!!!!!!!!!!!!!1
Posted: Tue Aug 23, 2005 4:28 pm
by loof101
my water thingy wont work. the water model. it isnt there but the pillar isnt either so the model didnt work and the pillar (Even thonugh
I'm saying this I higly dought that
)has turned invisible!
See
Posted: Tue Aug 23, 2005 4:35 pm
by mette
Hi Loof101,
I'm not completely sure about this, so bear with me if I'm wrong
. I think the water model is there, you just can't see it because it's below the floor level. I think you need to put water (or empty?) where you want your water model to show (water is transparent so you should be able to see your model through it).
If I'm wrong someone else will have to help you, since this is my only idea
Mette
Posted: Tue Aug 23, 2005 4:39 pm
by loof101
mette wrote:Hi Loof101,
I'm not completely sure about this, so bear with me if I'm wrong
. I think the water model is there, you just can't see it because it's below the floor level. I think you need to put water (or empty?) where you want your water model to show (water is transparent so you should be able to see your model through it).
If I'm wrong someone else will have to help you, since this is my only idea
Mette
Thanx!
Ill try THAT
Posted: Tue Aug 23, 2005 5:35 pm
by popo
Is it the water model I made for you Loofie? If it is then it should show up over the floor.
Try using Alt-X and 3 to go below ground level and see if it is there. If you're not getting a pillar then the model should be there somewhere.
I'll have a look at the one I made for you and see if there's something wrong.
Posted: Tue Aug 23, 2005 5:58 pm
by popo
I've just tested the water model I made - 14 x 12 pool - and it's ok. I don't think it's that one you're using. Try posting your model and I'll take a look at it.