The Wonderland Board

I know this is gonna sound goofy...but....had to reformat hard-drive and re-install everything I had, including Return to Wonderland. Then I downloaded and applied the version 1.01 patch. Had to start everything all over again and it was working fine until I got to the subject level.

You have 5 rocks to move to get them to cover certain buttons.

Numbering the rocks 1 - 5 from left to right.....I push rock 3 to cover the green button. I then push rock 5 to cover the pink button. I then move rock 1 out of the way...it goes nowhere. I then push rock 2 into the rock 4 which moves rock into the rock 5 position and leaves rock 2 in the rock 3 position which I then move to the 4 position.

I then push rock 5 out and it covers the blue button.

I then push rock in 4 position and it goes and hits the rock covering the green button which pushes that rock onto the yellow button and is supposed to leave a rock on the green button......but.....the rock blows up.

I didn't think rocks were supposed to blow up but stay put when they hit each other.

Can anyone help with this?????????

Merry Christmas to all and to all another long night with RTW.

I see the problem: That last boulder rolls off the conveyor and hits the boulder directly beneath it with such force that it blows that one up. You can roll them in a different pattern and avoid this problem. My solution below it you want it...




SPOILER:



I pushed boulders 5, 4 and 3, then pushed 1 out of the way and pushed 2 to 5. When you push this one, leave enough time so it doesn't collide with another at the end and blow them both up.