AAAAAAAAAAAAAAAHHHHHHHHHHHHHHH!!!!!!!!!!!!!!!!!!!!!!!!!!!1

loof101 · Post by **loof101** » Tue Aug 23, 2005 4:28 pm

my water thingy wont work. the water model. it isnt there but the pillar isnt either so the model didnt work and the pillar (Even thonugh
I'm saying this I higly dought that

)has turned invisible!

See

mette · Post by **mette** » Tue Aug 23, 2005 4:35 pm

Hi Loof101,

I'm not completely sure about this, so bear with me if I'm wrong

. I think the water model is there, you just can't see it because it's below the floor level. I think you need to put water (or empty?) where you want your water model to show (water is transparent so you should be able to see your model through it).

If I'm wrong someone else will have to help you, since this is my only idea

Mette

loof101 · Post by **loof101** » Tue Aug 23, 2005 4:39 pm

mette wrote:Hi Loof101,

I'm not completely sure about this, so bear with me if I'm wrong . I think the water model is there, you just can't see it because it's below the floor level. I think you need to put water (or empty?) where you want your water model to show (water is transparent so you should be able to see your model through it).

If I'm wrong someone else will have to help you, since this is my only idea

Mette

Thanx!

Ill try THAT

popo · Post by **popo** » Tue Aug 23, 2005 5:35 pm

Is it the water model I made for you Loofie? If it is then it should show up over the floor.

Try using Alt-X and 3 to go below ground level and see if it is there. If you're not getting a pillar then the model should be there somewhere.

I'll have a look at the one I made for you and see if there's something wrong.

popo · Post by **popo** » Tue Aug 23, 2005 5:58 pm

I've just tested the water model I made - 14 x 12 pool - and it's ok. I don't think it's that one you're using. Try posting your model and I'll take a look at it.